Mercury Administration: Mercury Connection Screen

From FloristWiki

---

Revision as of 11:13, 15 February 2011

If you are setting up your system to use the Internet to send and receive orders, the Mercury Connection screen allows you to enter your Internet account information.

IMPORTANT: It is strongly suggested to use this option only with the assistance of the Mercury Technology Assistance Center.

NOTE: In previous releases of FTD Mercury, this information could be found in the Account and Host tabs of the Connection Settings option.

You can configure the following settings on this screen:

Setting	Description
Communication Method	This is always set to Internet Access.
Account ID	Enter the account ID number that was provided to you by FTD.
Account User ID	Enter the Account User ID that was provided to you by FTD.
Account Password	Enter the account password that was provided to by FTD. Asterisks (*****) will mask the password as you type.
Confirm Password	Enter your password again to confirm it.
Primary Host Address	This is the address where your system sends and receives your orders and messages. You should not change the value in this field unless directed to by a Mercury Technology Assistance Center (MTAC) representative.
Secondary Address	This is a backup address to use if there is an interruption with the Primary Host Address. You should not change the value in this field unless directed to by a Mercury Technology Assistance Center (MTAC) representative.
Host Port	Type 80 in this field, unless otherwise instructed by FTD Mercury Support.
Polling Interval	Enter how often your system will dial out to send and receive any waiting orders or messages.
Blackout Begin	Enter the time the blackout period starts.
Blackout End	Enter the time the blackout period is to end.
Current Time Zone	Your current time zone. If this is incorrect, click Change Time Zone to set the value to the correct time zone.
Current Time	Your current time. If this is incorrect, click Change Time to set your time.

Accessing the Mercury Connection Screen

To access the Email screen in Mercury Administration:

1. Launch Mercury Administration.
2. Double-click Mercury Administration in the explorer pane.
3. Double-click the Communications folder.
4. Double-click Mercury Connection. The Mercury Connection screen opens.